I just picked up a Jameco JE RS232C interface board which didn't come with a case, and from the photos in the manual it didn't originally either, and so I was planning to make a VIC-1011A-alike 3d printed case for it. As I don't have a VIC 1011A to take measurements from, I was looking for good photos to try to extract the geometry from. I had a look at the Denial Wiki page for the VIC 1011A (link below), and noticed that it included a photo of the board as well as the cased design. Both that board and the Jameco one look identical as far as I can tell, but the photo isn't clear enough to read the silk screen text. Did Jameco make a direct knock-off of the Commodore design, did Commodore use the Jameco board (or the other way round) or is the photo on the wiki an error? Could someone who has a genuine VIC 1011A check?
http://sleepingelephant.com/denial/wiki ... ternal.jpg
VIC-1011A from wiki
Jameco JE 232CM
VIC1011A RS232C Interface
Moderator: Moderators
-
- Vic 20 Enthusiast
- Posts: 160
- Joined: Wed Feb 24, 2021 11:32 am
- Location: NC, USA
- Occupation: Engineer
Re: VIC1011A RS232C Interface
Not sure where I found this but this revision looks quite different
Re: VIC1011A RS232C Interface
Wait....I don't understand. Jameco is a vendor of all sorts of electronics parts. Are they currently selling this product?
Can you provide a link? (sorry, you didn't state whether this is an old item or a still available item from their website).
Why would they be selling a product intended for a computer from 40 years ago (unless they are vendors of new-old stock)?
What does their product description page say about this?
Can you provide a link? (sorry, you didn't state whether this is an old item or a still available item from their website).
Why would they be selling a product intended for a computer from 40 years ago (unless they are vendors of new-old stock)?
What does their product description page say about this?
![Image](http://s1.bcbits.com/img/buttons/bandcamp_22x22_black.png)
-
- Vic 20 Enthusiast
- Posts: 160
- Joined: Wed Feb 24, 2021 11:32 am
- Location: NC, USA
- Occupation: Engineer
Re: VIC1011A RS232C Interface
Sorry, I should have been more clear - I picked it up on e-bay. The date code on the d-sub connector is from 1984