VIC1011A RS232C Interface
Posted: Fri Jul 22, 2022 6:14 am
I just picked up a Jameco JE RS232C interface board which didn't come with a case, and from the photos in the manual it didn't originally either, and so I was planning to make a VIC-1011A-alike 3d printed case for it. As I don't have a VIC 1011A to take measurements from, I was looking for good photos to try to extract the geometry from. I had a look at the Denial Wiki page for the VIC 1011A (link below), and noticed that it included a photo of the board as well as the cased design. Both that board and the Jameco one look identical as far as I can tell, but the photo isn't clear enough to read the silk screen text. Did Jameco make a direct knock-off of the Commodore design, did Commodore use the Jameco board (or the other way round) or is the photo on the wiki an error? Could someone who has a genuine VIC 1011A check?
http://sleepingelephant.com/denial/wiki ... ternal.jpg
VIC-1011A from wiki Jameco JE 232CM
http://sleepingelephant.com/denial/wiki ... ternal.jpg
VIC-1011A from wiki Jameco JE 232CM